PROGRAMACIÓN DE LA UNIDAD DIDÁCTICA: “SISTEMAS DE REPRESENTACIÓN Y DISEÑO ASISTIDO POR ORDENADOR” PARA TECNOLOGÍA 3º ESO
Fecha
2021-10-15
Autores
Título de la revista
ISSN de la revista
Título del volumen
Editor
Jaén: Universidad de Jaén
Resumen
[ES] El presente Trabajo Fin de Master consiste en el diseño de la unidad didáctica sobre los sistemas
de representación y el diseño asistido por ordenador en 3 dimensiones, encuadrados en el bloque 2
de contenidos “Expresión y comunicación técnica” de la materia de Tecnología, destinada al tercer
curso de Educación Secundaria Obligatoria.
La elaboración de la programación didáctica se ha llevado a cabo en consonancia con la normativa
educativa estatal y andaluza vigente en la fecha de inicio del curso 2020/2021, 1 de septiembre de
2020. En base a esa normativa, utilizando los conocimientos, habilidades y destrezas adquiridas a lo
largo del máster, se ha aplicado una metodología activa junto con unos recursos didácticos variados y
originales con el objeto de motivar al alumnado para la adquisición de las competencias clave y el
logro de los objetivos planteados en el proceso de enseñanza-aprendizaje.
[EN] This Master's Thesis consists of the design of the didactic unit on representation systems and computer- aided design in 3 dimensions, included in the content block 2 "Technical expression and communication" of the subject of Technology, aimed at the third year of Compulsory Secondary Education. The didactic programming has been carried out in accordance with the state and Andalusian educational regulations in force at the start of the 2020/2021 academic year, 1 September 2020. Based on these regulations, using the knowledge, skills and abilities acquired throughout the master's degree, an active methodology has been applied together with varied and original teaching resources in order to motivate students to acquire key competences and achieve the objectives set out in the teaching-learning process.
[EN] This Master's Thesis consists of the design of the didactic unit on representation systems and computer- aided design in 3 dimensions, included in the content block 2 "Technical expression and communication" of the subject of Technology, aimed at the third year of Compulsory Secondary Education. The didactic programming has been carried out in accordance with the state and Andalusian educational regulations in force at the start of the 2020/2021 academic year, 1 September 2020. Based on these regulations, using the knowledge, skills and abilities acquired throughout the master's degree, an active methodology has been applied together with varied and original teaching resources in order to motivate students to acquire key competences and achieve the objectives set out in the teaching-learning process.