CARACTERIZACIÓN MECÁNICA DE PROBETAS IMPRESAS EN MATERIAL CERÁMICO
Archivos
NO SE HA AUTORIZADO la consulta de los documentos asociados
Fecha
2024-09-19
Autores
Título de la revista
ISSN de la revista
Título del volumen
Editor
Jaén: Universidad de Jaén
Resumen
Uno de los principales problemas de las piezas fabricadas mediante SLA es la reducción de sus propiedades
mecánicas en comparación con los métodos tradicionales. En este estudio, se investiga el comportamiento
del material cerámico alúmina fabricada mediante SLA. Se analiza cómo diferentes orientaciones de
impresión afectan a la resistencia mecánica del material mediante un ensayo a flexión. Además, debido a
la porosidad de los materiales cerámicos, se realiza un ensayo de densidad para comprobar la efectividad
del procesamiento.
Una vez diseñada la pieza, se imprime mediante tecnología SLA. Luego, se realiza el quemado para eliminar
el plástico, y el sinterizado para compactar y dar resistencia a la pieza. A continuación, realizamos los
ensayos correspondientes. Se lleva a cabo un ensayo de flexión en tres puntos, donde se obtienen y
analizan la carga máxima de rotura y la deformación máxima. También se realiza el ensayo de densidad
mediante un método de desplazamiento de líquido analizando la densidad aparente y la porosidad abierta.
Por último, sacamos las conclusiones oportunas extraídas de los ensayos en función de los parámetros de
impresión.
One of the main issues with parts manufactured by SLA is the reduction of their mechanical properties compared to traditional methods. This study investigates the behavior of alumina ceramic material produced by SLA. It analyzes how different printing orientations affect the material's mechanical strength through a flexural test. Additionally, due to the porosity of ceramic materials, a density test is conducted to check the effectiveness of the processing. Once the part is designed, it is printed using SLA technology. Then, burning is performed to remove the plastic, and sintering is done to compact and strengthen the part. Next, the corresponding tests are carried out. A three-point bending test is conducted to obtain and analyze the maximum breaking load and maximum deformation. The density test is also performed using a liquid displacement method, analyzing the apparent density and open porosity. Finally, the appropriate conclusions are drawn from the tests based on the printing parameters
One of the main issues with parts manufactured by SLA is the reduction of their mechanical properties compared to traditional methods. This study investigates the behavior of alumina ceramic material produced by SLA. It analyzes how different printing orientations affect the material's mechanical strength through a flexural test. Additionally, due to the porosity of ceramic materials, a density test is conducted to check the effectiveness of the processing. Once the part is designed, it is printed using SLA technology. Then, burning is performed to remove the plastic, and sintering is done to compact and strengthen the part. Next, the corresponding tests are carried out. A three-point bending test is conducted to obtain and analyze the maximum breaking load and maximum deformation. The density test is also performed using a liquid displacement method, analyzing the apparent density and open porosity. Finally, the appropriate conclusions are drawn from the tests based on the printing parameters