Diseño CAD y validación de un molde de inyección para la fabricación de una pieza plástica por moldeo
Archivos
NO SE HA AUTORIZADO la consulta de los documentos asociados
Fecha
2021-06-30
Autores
Título de la revista
ISSN de la revista
Título del volumen
Editor
Jaén: Universidad de Jaén
Resumen
En el presente Trabajo Fin de Grado se pretende realizar el diseño de una pieza de plástico del sector de la
automoción, a través del software CAD CATIA V5. Con este diseño, se pretende validar y la fabricar el molde de
la misma (validación, dimensionamiento y diseño del mismo mediante el mismo software, así como otros de
validación).
In this project a design of a plastic part of an automobile engine will be made by the author. The mainly purpose of this study is to obtain the design of this part through a CAD software (CATIA V5), in order to validate and manufacture its mold (validation, sizing and design by the same software and others).
In this project a design of a plastic part of an automobile engine will be made by the author. The mainly purpose of this study is to obtain the design of this part through a CAD software (CATIA V5), in order to validate and manufacture its mold (validation, sizing and design by the same software and others).